-40%

Aluminized Reflective Insulation Hose Pipe Wrap Turbo Heat Shield 2" x 49ft Tape

$ 10.55

Availability: 25 in stock
  • Brand: Unbranded
  • Refund will be given as: Money back or replacement (buyer's choice)
  • Item must be returned within: 30 Days
  • Manufacturer Part Number: Does Not Apply
  • Returns Accepted: Returns Accepted
  • Condition: New
  • Country/Region of Manufacture: India
  • Restocking Fee: No
  • Return shipping will be paid by: Seller

    Description

    Aluminized Fiberglass exhaust wrap is a heat insulation product for exhaust pipes, headers, manifolds or turbo piping. It is work by trapping the heat in the exhaust and increasing the internal temperature, this allows the exhaust to exit the system faster. With increased exhaust scavenging comes lower intake temperatures, this leads to an increase in both horsepower and fuel efficiency.
    On the motorcycle, by using this wrap, it provides two advantage, along with increasing engine performance protects both bike frame & body & protect legs from burning.
    This wrap can be used on motorcycles, trucks, cars, and almost any other vehicle.
    Specification
    :
    Inner Material: Fiberglass
    Outer Material: Aluminium Alloy Mylar Foil
    Withstand Temperature
    : 1000°F (537°C) Continuous
    Radiant Heat Protect: 2000°F (1093°C)
    Thickness: 1/16 Inch (1.5mm)
    Width: 2 Inch (50mm)
    Length: 49.2 Feet (15 Mtr.)
    Advantages
    :
    Extends engine life
    Increase horsepower & fuel efficiency
    Will reduce turbo leg
    Extends life of headers, wrap hoses, pipes, hardware of supercharger & turbo tubes and more
    Protects under hood wiring & electronics
    Easily install
    Application
    :
    Air Intake
    Exhaust headers & pipes
    Intercooler
    Supercharger
    Turbo pipes & tubing
    Starter
    Hose
    Wiring
    Cold air induction system
    Protect body parts & components
    Installation Procedure:
    Wear hand gloves and a long sleeve shirt to avoid itching & irrigation.
    Wrap will smoke lightly after initial installation.
    Starting at the flange end leave about 0.25 inch – 0.5 inch for hardware
    Each wrap should be overlap the previous layer by approximately 0.25 inch – 0.5 inch
    Turns and curves will have more of an overlap
    Try to keep the wrap continuously to the end of the pipe
    Must be use stainless steel tie at the first & last end of pipe to hold of wrap in place
    Find our more products at simondstore:
    https://www.ebay.com/str/simondstore/
    If you have any query related to product, request you to message us on ebay.com, it will be our privilege to provide you solution at the earliest & serve you better.
    We kindly request you to give us the 100% positive feedback as you will be completely satisfied with the product.
    SAFETY INSTRUCTIONS: WEAR SAFETY MASK | WEAR SAFETY GLASSES | WEAR SAFETY GLOVES
    Image displayed is for illustrative purpose only. Actual product may vary the displayed image but features and specification would be same or higher as defined above.